Starter Vape Kit traceability quick reference guide
Starter Vape Kit is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Published 20 March 2025 · VapeWholesaleHub · Reading time 5 min
Getting the carton there intact
We work with former smokers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.
Documentation travels with the goods: commercial invoice, packing list, and the certificate set for your market. We send a scanned copy before dispatch so your broker can clear the file in advance.
What your market will ask for
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
We keep batch codes traceable from carton to production date. When a market authority asks for traceability, a supplier who cannot produce it in an hour becomes a liability very quickly.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
10 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.
- Cartons drop-tested and pallet-counted for clean freight
- Batch codes traceable from carton back to production date
- Document pack prepared per destination market
- Consolidated or split shipping, quoted both ways
- Specification locked in writing before production starts
- Mixed SKU cartons to spread first-order risk
Merchandising a small range well
Shelf position decides velocity as much as price. Keep starter vape kits at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Bundle a device with a consumable and the reorder rhythm changes from occasional to weekly. That single merchandising decision often does more for monthly revenue than a price promotion.
Specification summary
| Battery | 500 mAh |
| Pod capacity | 3.0 ml |
| Coil resistance | 1.0 ohm |
| Included | Device, 2 pods, cable |
| Charging | USB-C 5V/1A |
| Packaging | Retail box |
| Minimum order | 300 units per SKU, mixed cartons allowed |
| Lead time | 22 working days after artwork approval |
The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What is the minimum order for starter vape kit?
Standard configurations start at 60 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 240 units because of setup time on the line.
How long does production take?
Around 15 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz